Installation Instructions Installation of the Arrest Star Door Holder/Stop is a snap with just 4 fasteners. Step one determine position you require the door to be stopped and held. Factors to be considered are door clearance (Fig 1 not enough on bumper), trip hazard, ease of use (Fig 2 not a trip hazard easy to use). (Warning! Do not install in any unsafe manner. Use of this device is at your own risk and discretion. Use this device only in strict compliance with all federal, state and local government regulations.)
(Fig 1)
(Fig 2)
Step two mark fastener locations and choose the most suitable fastening system.(Fig 3)
(Fig 3)
(Fig 4)
(The ArreStar will work on multiple doors and locations. You must choose the best fasteners or fastening system for your location. Lag screws, wedge anchors, sleeve anchors, epoxy, and drive pins are all good options; the maximum recommended diameter is ¼”. Please follow the manufacturer’s instructions for your application.)
